Hioki IM3536 - Page 210

204
Function specications
• USB
Terminator CR+LF, CR (Default setting: CR+LF)
• LAN
IP address Four 3-digit values (from 0 to 255 each)
(Default setting: 192.168.000.001)
Subnet mask Four 3-digit values (from 0 to 255 each)
(Default setting: 255.255.255.000)
Default gateway Four 3-digit values (from 0 to 255 each) (Default setting: OFF)
Port number 1024 to 65535 (Default setting: 3500)
Terminator CR+LF, CR (Default setting: CR+LF)
Instrument information
Serial number information Displays the serial number.
Version information Displays the software version and the FPGA version.
MAC address Displays the MAC address.
USB ID Displays the USB ID.
Self-check function
Panel test Allows you to check for touch panel errors.
Panel calibration Allows you to calibrate the touch panel.
Display status test Allows you to check the screen display status and LED status.
ROM/RAM test Allows you to check the instrument’s internal memory (ROM and RAM) for
errors.
EXT I/O test Allows you to verify that output signals are output normally from EXT I/O
and that input signals can be read properly.
Time setting
Time and date setting Sets the year, month, day, hour, minute, and second.