Hiwin D1-N Series - Page 128

D1-N Series Servo Drive User Manual Servo Drive Configuration
5-50 HIWIN MIKROSYSTEM Corp.
MD17UE01-1906
Note:
“V” means the output function is supported.
Output Function Errors Applicable Operation Mode Pos Vel Trq Std
Abbr.
ALM
Default Output
O1
Wiring Diagram
Refer to section 4.7.2.
 Function
Users are allowed to output error statuses.
 Description
Users can select Errors (Default output: O1) for one output in Outputs tab of I/O center.
Click on Configure O1 button to show Configuration of O1 window. Click on Set all errors button to
select all the listed errors. The status field will display “Errors”. If not all the listed errors are selected,
the status field will display “Customized”.