Panther System
®
Operator’s Manual
AW-17791-001 Rev. 002 (EN)
169
System Operation
Filter Description
Creation Date The following three (3) choices are available for use
as a report filter:
l Today
l Yesterday
l Range
Check the cell of the date range desired. Selecting
the Range cell opens a window to refine the date and
time range.
Show both
diagnostic and
non-diagnostic
messages
Check either Yes or No to display desired messaging
in the report. Selecting Yes displays additional system
communication messaging that is not shown on the
Messages screen.
Severity The following six (6) choices are available for use as
a report filter:
l Message
l Warning
l Problem
l Critical
l Fatal
l Undefined
Check the Severity cell and then check the cell of the
system message category desired.
Priority The following three (3) choices are available for use
as a report filter:
l High
l Low
l Informational
Check the Priority cell and then check the cell of the
system message category desired.
Event ID Check the Event ID cell and enter the event ID for the
desired message in the open field.
Table 75. Diagnostics Log Report—Report Parameters
To Next Page
Loading...
