Panther System
®
Operator’s Manual
AW-17791-001 Rev. 002 (EN)
227
System Administration
ISBT128 Barcodes Enabled
Check the Enable Non-Barcode Sample Loading configuration to accept specimens
labeled with ISBT128 symbology. Once the cell has been checked, the Specimen
Loading window opens for the operator to select the barcode stripping mode. Select one
of the following three (3) stripping modes during configuration:
Option Description
Include Prefix
and Postfix
Include prefix and postfix characters
in SID.
Exclude Prefix
Only
Exclude the prefix characters from the
SID.
Exclude Prefix
and Postfix
Exclude both the prefix and postfix
characters from the SID.
Table 102. ISBT128 Barcodes Stripping Options
After selecting the stripping mode, select OK to enable the parameter. When enabled, the
parameter strips the characters as selected to align with the configuration of your host
system.
Results Management
Use the options available in the Results Management expansion menu to configure the
Results Management process as needed.
Select and configure the following options within the menu:
Option Description
Enable Result
Verification
Check this cell to require verification of test results
before exporting LIS data is allowed.
Enable RLU value
suppression for
Aptima Combo 2
Check this cell to enable RLU suppression for non-
positive results when selecting single-analyte
screening in the Aptima Combo 2 assay.
Additional instructions provided below.
Set Panther Calibrator
and/or Control
frequency
Check this cell to adjust the calibrator/control validity
period to less than the default.
Table 103. Results Management Options
To Next Page
Loading...
