Panther System
®
Operator’s Manual
AW-17791-001 Rev. 002 (EN)
66
Overview
Screen Location Description
7. *New Ctrl/Cal Lot Select this button to enter control/calibrator lot
information for designated assays (see Adding a
New Control/Calibrator Lot on page 113).
8. Lane Details Sample ID and associated assay test order
information for the samples loaded in a selected
Sample Bay Lane.
9. Set Select this button to choose the sample default
criteria.
10. Sample Defaults
Panel
Current sample default criteria (see Sample Defaults
on page 117).
*This button is only visible under certain system software configurations.
Table 36. Sample Rack Bay Screen Descriptions (Continued)
Sample Rack Loading Screen
To access the Sample Rack Loading screen:
l Select the graphic of a Sample Bay Lane on the Sample Rack Bay screen and then
select the Rack Details button.
l Double-click the Sample Bay Lane graphic of a loaded rack on the Sample Rack Bay
screen (see Sample Rack Bay Screen on page 64).
Operators are automatically directed to this screen during the loading process when
further operator input is needed. Several buttons on this screen are conditionally-
dependent and will only appear under certain loading scenarios. For example, External
Quality Control (EQC) buttons and reflex testing buttons will only be available if the
system is configured for these options and the selected Sample Rack contains tubes
associated with these testing categories.
The operator can also navigate to the Sample Rack Loading screen for adding test orders
for the entire Sample Rack, as well as designating STAT for all specimens in the Sample
Rack.
To Next Page
Loading...
