Hologic Panther System - Printer Management; Default Printer Name; Table 108. UPS Management Setting Options; Table 109. Printer Settings Options

Panther System
®
Operator’s Manual
AW-17791-001 Rev. 002 (EN)
235
System Administration
Select and configure the following option within the menu:
Option Description
Enable UPS
Shutdown
Select this cell to enable automatic shutdown of the system
following an extended loss of power.
Table 108. UPS Management Setting Options
Once the Enable UPS Shutdown setting is enabled, the UPS icon appears in the Status
Panel. The icon can appear in the following two states:
l Icon not flashing—UPS connected
l Icon flashing—UPS connection not detected
The operator can also select the UPS icon for additional status information. Available
status messages include the following:
l No UPS found
l Power Source: AC (Battery Charge x%)
l Power source: Battery (Battery Charge x%)
Printer Management
Use the Printer Management expansion menu to configure the printer settings as
needed.Contact Hologic personnel to assist with networking the printer.
Select and configure the following option within the menu:
Option Description
Default Printer
Name
Select this field to adjust the name for the printer to be used with
the system.
Additional instructions provided below.
Table 109. Printer Settings Options
Default Printer Name
To select the printer to use with the system:
1. From the expanded Printer Settings menu on the System Configuration screen, select
the Default Printer Name field.
A Default Printer Selection window opens.
2. From the window, select the printer to use with the Panther System.
3. Select OK when finished.