Index
3/07 UDC3500 Universal Digital Controller Product Manual 441
Software Version.............................................350
Software Version Number...............................307
Solid State Relay Output...................................35
SP Ramp Set Up Group..................57, 63, 66, 69
SP Ramp/Rate/Program#1 – Register Addresses
....................................................................359
SP Ramp/Rate/Program#2 – Register Addresses
....................................................................365
SP Ramp/Rate/Program#3 – Register Addresses
....................................................................371
SP Ramp/Rate/Program#4 – Register Addresses
....................................................................377
SP Tuning .........................................................72
Specifications....................................................13
Start Segment Number ...................................245
Start Up Procedure For Operation ..................199
Status Data .....................................................262
Status Data – Diagnostics History...................263
Status Tests....................................................308
Stray Rejection..................................................13
Summer With Ratio And Bias............................82
Summer/Subtractor.............................................2
Suppression Devices ........................................23
Switch Between Two Sets Via Keyboard ........214
Switching Between Setpoints..........................202
Switchover Value ............................................144
T
Temperature Units ..........................................176
Test Failures ...................................................308
Thermocouple Diagnostic Messages ..............177
Thermocouple Health..........................................2
Thermocouple Inputs Using A Thermocouple
Source.........................................................281
Thermocouple Inputs Using An Ice Bath.........280
Third Current Output Calibration Procedure....299
Third Current Output Range............................152
Three Position Control Step Output Start-Up
Mode...........................................................137
Three Position Step ..........................................79
Three Position Step Control......................37, 300
Three Position Step Control Algorithm............236
Three Position Step Test Failures...................308
Three Relay Board............................................14
Time Current Duplex...............................106, 109
Time Duplex............................................106, 109
Time Event – Register Addresses...................428
Time Events Set Up Group.............................179
Time Proportional Output................105, 106, 109
Time Proportional Output Failure....................321
Time Remaining..............................................203
Time Simplex ..........................................105, 109
Time-Out.........................................................203
Timer.............................................4, 80, 173, 203
Totalizer ..............................................................3
Totalizer Data..................................................267
Totalizer Displays............................................216
Totalizer Function........................................80, 95
Totalizer Reset Via Digital Input......................217
Transmitter Characterization..117, 121, 124, 126,
129
Transmitter Power.............................................. 4
Transmitter Power For 4-20 Ma ............11, 41, 42
Troubleshooting Aids ......................................
306
Troubleshooting Procedures ...........................315
Troubleshooting/Service..................................305
Tune................................................................205
Tune For Duplex (Heat/Cool) ..........................207
Tune For Simplex Outputs ..............................206
Tuning.........................................................50, 54
Tuning Constants............................................... 5
Tuning Indicators.............................................204
Tuning Loop 1 – Register Addresses ..............356
Tuning Loop 2 – Register Addresses ..............358
Tuning Parameter Sets ...................................132
Tuning Parameter Sets—Loop 2.....................141
Tuning Set Up Group ..................................50, 54
Two Loops Of Control .....................................228
Two Sets Of Tuning Constants .......................213
TX Delay .........................................................161
U
Universal Output Functionality And Restrictions
................................................................24, 25
Universal Switching Power................................. 4
V
Vibration............................................................16
Voltage And Resistance Equivalents For 0% And
100% Range Values....................................276
W,X,Y,Z
Weight...............................................................15
Weighted Average.............................................. 2
Weighted Average Ratio ...................................85
Wiring................................................................22
Wiring Bundling.................................................23
Wiring Connections For Calibrating The First
Current Output ............................................294
Wiring Connections For Calibrating The Second
Current Output ............................................296
Wiring Connections For Calibrating Third Current
Output .........................................................298
Wiring Connections For Dual High Level
Milliampere Inputs.......................................288
Wiring Connections For Radiamatic, Milliampere,
Millivolts, Or Volts (Except 0 To 10 Volts) ..283,
286, 287
Wiring Connections For RTD (Resistance
Thermometer Device) .................................282
Wiring Diagrams................................................24
Wiring The Controller ........................................27
Worksheet.......................................................244
WS Float .........................................................161