Output Calibration
3/07 UDC3500 Universal Digital Controller Product Manual 295
6 Output Calibration
6.1 Overview
Introduction
This section describes the field calibration procedures for the following types of outputs:
• Current Outputs
• Position Proportional Output and Three Position Step Output
What’s in this section?
The following topics are covered in this section.
TOPIC See Page
6.1 Overview 295
6.2 First Current Output Calibration 296
6.3 Second Current Output Calibration 298
6.4 Third Current Output Calibration 300
6.5 Position Proportional and Three Position Step Output Calibration 302
6.6 Restore Factory Output Calibration 305
WARNING—SHOCK HAZARD
OUTPUT CALIBRATION MAY REQUIRE ACCESS TO HAZARDOUS LIVE CIRCUITS, AND
SHOULD ONLY BE PERFORMED BY QUALIFIED SERVICE PERSONNEL. MORE THAN
ONE SWITCH MAY BE REQUIRED TO DE-ENERGIZE UNIT BEFORE CALIBRATION.
To Next Page
Loading...
