Honeywell UDC3500 - Tuning Loop2; Table 10-11 Set-Up Group - Tuning Loop 2

Modbus Read, Write and Override Parameters plus Exception Codes
360 UDC3500 Universal Digital Controller Product Manual 3/07
10.7.2 Tuning Loop2
Table 10-11 lists all the register addresses and ranges or selections for the function
parameters in the Set-up Group – Tuning Loop 2.
Table 10-11 Set-up Group – Tuning Loop 2
Parameter Register
Address
Data
Type
Access Data Range or
Enumerated Selection
Description ID Hex Decimal
Gain #5 or PB
Note 1
1 0101 257 FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
Rate #5
Note 1
2 0102 258 FP R/W 0.00 to 10.00
Reset #5
Note 1
3 0103 259 FP R/W 0.02 to 50.00
Manual Reset 13 010D 269 FP R/W -100 to 100
Gain #6 or PB
Note 1
4 0104 260 FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
Rate #6
Note 1
5 0105 261 FP R/W 0.00 to 10.00
Reset #6
Note 1
6 0106 262 FP R/W 0.02 to 50.00
Gain #7 or PB
Note 1
23 0117 279 FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
Rate #7
Note 1
24 0118 280 FP R/W 0.00 to 10.00
Reset #7
Note 1
25 0119 281 FP R/W 0.02 to 50.00
Gain #8 or PB
Note 1
26 011A 282 FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
Rate #8
Note 1
27 011B 283 FP R/W 0.00 to 10.00
Reset #8
Note 1
28 011C 284 FP R/W 0.02 to 50.00
Cycle Time #5 21 0115 277 FP R/W 1 to 120 seconds
Cycle Time #6 22 0116 278 FP R/W 1 to 120 seconds