Honeywell UDC3500 - Table 10-8 Computer Setpoint Associated Parameters for Loop 1

Modbus Read, Write and Override Parameters plus Exception Codes
356 UDC3500 Universal Digital Controller Product Manual 3/07
Table 10-7.1 Shed Timer Reset
Parameter Register
Address
Data
Type
Access Data Range or
Enumerated Selection
Description ID Hex Decimal
Shed Timer
Reset Loop1
127 007F 127 FP W Exit Slave Mode
Shed Timer
Reset Loop2
127 017F 383 FP W Exit Slave Mode
Associated Parameters
Refer to Table 10-8 for the codes to display or change any of the parameters associated
with the computer setpoint on loop 1.
Table 10-8 Computer Setpoint Associated Parameters for Loop 1
Parameter Register Address
Description ID
Hex Decimal
Setpoint Limits 7,8 0007, 0008 007, 008
Local Setpoint #1 39 0027 039
Local Setpoint #2 53 0035 053
Local Setpoint #3 116 0074 116
Local Setpoint #4 112 0070 112
Local Setpoint Selection 173 00AD 173
Computer Setpoint Ratio 90 005A 90
Computer Setpoint Bias 91 005B 91
Shed Timer Reset 127 007F 127