HP 4000

2-3
System Error Codes
HP Designjet 4000/4020 Printer Series Service Manual
System Error: 01.0:03
Problem
Description:
Error impact I2C channel.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 If the System Error continues, replace the Gamut PCI PCA ⇒ Page 8-98.
System Error: 01.0:10
Problem
Description:
Problem with the Gamut PCI PCA.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Replace the Gamut PCI PCA ⇒ Page 8-98.
 If the System Error continues, replace the Main PCA ⇒ Page 8-105.
Only replace one component at a time and check if the error
has gone before replacing another component. Using this
procedure you will be able to determine exactly which
component failed.
System Error:
01.1:10
Problem
Description:
Problem with the PrintMech PCA.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Check that the cables between the PrintMech PCA and the Gamut PCI
PCA are not damaged and are correctly connected.
 Replace the PrintMech PCA ⇒ Page 8-119.
 If the System Error continues, replace the Gamut PCI PCA ⇒ Page 8-98.
Only replace one component at a time and check if the error
has gone before replacing another component. Using this
procedure you will be able to determine exactly which
component failed.