HP 4000 User Manual

2-14
System Error Codes
HP Designjet 4000/4020 Printer Series Service Manual
System Error:
42:03
Problem
Description:
Electrical current limit in Scan-Axis Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Open the Window and check for any visible obstacles restricting the
movement of the Carriage Assembly. If there is a wrinkled mass of media
blocking the Carriage Assembly, then clear the obstruction.
 Replace the Scan-Axis Motor ⇒ Page 8-88.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-119.
System Error: 42:10
Problem
Description:
Electrical fault in Scan-Axis Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Check that the Scan-Axis Motor cable is not damaged and is correctly
connected to the PrintMech PCA.
 Replace the Scan-Axis Motor ⇒ Page 8-88.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-119.
System Error: 43:10
Problem
Description:
Vacuum Fan has stopped functioning.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Check that the Vacuum Fan cables are not damaged and are correctly
connected to the Interconnect PCA.
 Also check that the cables between the Interconnect PCA and the
PrintMech PCA are not damaged and are correctly connected.
 Replace the Vacuum Fan ⇒ Page 8-27.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-119.

HP 4000 Specifications

General

Brand	HP
Model	4000
Category	Printer
Language	English