HP 420

General System Configuration
Configuring SNMP
• localMacAddrAuthFail – A client station has failed authentication
with the local MAC address database on the access point.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.12)
• iappStationRoamedFrom – A client station has roamed from
another access point (identified by its IP address).
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.13)
• iappStationRoamedTo – A client station has roamed to another
access point (identified by its IP address).
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.14)
• iappContextDataSent – A client station’s Context Data has been
sent to another access point with which the station has associated.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.15)
• sntpServerFail – The access point has failed to set the time from the
configured SNTP server.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.16)
• dot1xSuppAuthenticated – The access point has been successfully
authenticated with the RADIUS server.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.21)
• wirelessExternalAntenna – An external antenna has been attached
or detached from the access point.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.22)
• possibleRogueApDetected – An access point has been detected
during a neighbor detection scan.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.23)
• httpEnableStatusSet – The access point’s web server has been
enabled or disabled. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.24)
• httpsEnableStatusSet – The access point’s secure web server has
been enabled or disabled.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.25)
• cliSerialPortEnableStatusSet – Management access through the
serial port has been enabled or disabled.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.26)
• cliTelnetPortEnableStatusSet – Management access through
Telnet has been enabled or disabled.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.27)
• snmpVersionFilterSet – The filter for SNMPv3 or SNMP v1/v2
management access has been changed.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.28)
• resetButtonEnableStatusSet – The access point’s reset button has
been enabled or disabled.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.29)
5-35