Setting Dynamic Power Capping FunctionalitySetting Dynamic Power Capping Functionality
Use the Setting Dynamic Power Capping Functionality option to configure when the system ROM executes power calibration during the
boot process.
ProcedureProcedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > System Options > Boot
Time Optimizations > Dynamic Power Capping Functionality.
2. Select a setting.
Auto—Power calibration runs the first time the server is booted and is only run again when the hardware configuration settings
of the server change.
Enabled—Power calibration runs on every system boot.
Disabled—Power calibration does not run, and Dynamic Power Capping is not supported.
3. Save your setting.
To Next Page
Loading...
