Enabling embedded chipset SATA controller supportEnabling embedded chipset SATA controller support
Use the Embedded SATA Configuration option to enable embedded chipset SATA (Serial Advanced Technology Attachment) controller
support. You can select AHCI or HPE Smart Array SW RAID Support. Make sure that you are using the correct operating system drivers
for your selected option.
CAUTION:CAUTION:
Dynamic Smart Array is not supported when the boot mode is configured to Legacy BIOS Mode. Enabling Dynamic
SmartRAID RAID results in data loss or data corruption on existing SATA drives. Back up all drives before enabling this
option.
See your operating system documentation before enabling SATA AHCI support to ensure your base media drivers
support this feature.
PrerequisitesPrerequisites
The correct operating system drivers for your selected option.
Boot Mode is set to UEFI Mode.
ProcedureProcedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Storage Options > SATA
Controller Options > Embedded SATA Configuration .
2. Ensure that you are using the correct ACHI or RAID system drivers for your SATA option.
3. Select a setting.
SATA AHCI Support —Enables the embedded chipset SATA controller for AHCI.
SmartRAID SW RAID Support—Enables the embedded chipset SATA controller for Dynamic SmartRAID RAID.
Intel VROC SATA Support
4. Save your setting.
To Next Page
Loading...
