HP ProLiant Gen10 - Getting Started with UEFI System Utilities; UEFI System Utilities Overview; Launching System Utilities; Navigating System Utilities

Table of contentsTable of contents
1 Getting Started
1.1 UEFI System Utilities
1.1.1 What is UEFI?
1.2 UEFI System Utilities overview
1.2.1 Launching the System Utilities
1.2.2 Navigating the System Utilities
1.2.2.1 Navigating the System Utilities in GUI mode
1.2.2.1.1 UEFI System Utilities GUI
1.2.2.1.2 System Utilities key functions
1.2.2.2 When is a reboot required?
1.2.3 System Utilities menu overview
1.2.4 Common setup and configuration FAQs
1.2.5 Updating firmware or system ROM
2 System Utilities main menu options
2.1 System Configuration
2.1.1 System Configuration menu options
2.1.2 BIOS/Platform Configuration (RBSU)
2.1.3 Using the iLO 5 Configuration Utility
2.1.3.1 iLO 5 Configuration Utility options
2.1.3.2 Network Options
2.1.3.3 Configuring Network Options
2.1.3.4 Advanced Network Options
2.1.3.5 Configuring Advanced Network Options
2.1.3.6 User Management
2.1.3.7 Add User
2.1.3.8 Adding new user accounts
2.1.3.9 Edit/Remove User
2.1.3.10 Editing or removing user accounts
2.1.3.11 Setting Options
2.1.3.12 Configuring access settings
2.1.3.13 Set to factory defaults
2.1.3.14 Resetting iLO to the factory default settings
2.1.3.15 Reset iLO
2.1.3.16 Resetting iLO active connections
2.1.3.17 About
2.1.3.18 Viewing information about iLO
2.1.4 Viewing and configuring embedded device information
2.1.4.1 Viewing controller information
2.1.4.2 Configuring controller settings
2.1.4.2.1 Modifying controller settings
2.1.4.2.2 Modifying advanced controller settings
2.1.4.2.3 Clearing the controller configuration