Server will not bootServer will not boot
CauseCause
Enable serial debug with the maintenance switch.
ActionAction
1. Power off the server.
2. Locate the Server Maintenance Switch (12 position switch) and set DIP 4 to the ON position. Refer to the chassis hood label for
details on the location of the switch.
3. Attach a NULL mode cable to the server serial port or open an iLO Virtual Serial Port (VSP) session.
4. Use a utility, such as PuTTY, to establish the connection and ensure that you enable logging to a file (select All session outputAll session output ).
The following example shows sample PuTTY settings for logging data:
To Next Page
Loading...
