Setting the power-on passwordSetting the power-on password
Use the Set Power On Password option to set a password for accessing the server during the boot process. When you are powering on
the server, a prompt appears where you enter the password to continue. To disable or clear the password, enter the password followed
by a / (slash) when prompted to enter the password.
NOTE:NOTE:
In the event of an Automatic Server Recovery (ASR) reboot, the power-on password is bypassed and the server boots
normally.
ProcedureProcedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Server Security > Set Power
On Password.
2. Enter your password.
A password can be:
31 characters maximum
Any combination of numbers, letters, and special characters
3. Confirm the password, and then press Enter.
A message appears confirming that the password is set.
4. Save your changes.
5. Reboot the server.
To Next Page
Loading...
