Enabling or disabling Memory Fast TrainingEnabling or disabling Memory Fast Training
Use the Memory Fast Training option to configure memory training on server reboots. When enabled, the platform uses the previously
saved memory training parameters determined from the last cold boot of the server, which improves server boot time. When installed
on your server, and this setting is enabled, NVDIMM-N Memory contents are left undisturbed during warm resets. If Memory Fast
Training is disabled, each warm reset is upgraded to a cold reset and results in an NVDIMM-N backup and restore. Hewlett Packard
Enterprise recommends that you leave Memory Fast Training enabled.
ProcedureProcedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > System Options > Boot
Time Optimizations > Memory Fast Training.
2. Select a setting.
Enabled—Enables the server to use previously saved memory training parameters.
Disabled—The platform performs a full memory training on every server reboot.
3. Save your setting.
To Next Page
Loading...
