HP ProLiant Gen10 - Sanitization with UEFI System Utilities

Sanitization with UEFI System UtilitiesSanitization with UEFI System Utilities
Review the sanitization policies and guidelines in this guide before sanitizing a HPE Persistent Memory module.
ProcedureProcedure
1. From the System Utilities screen, select System ConfigurationSystem Configuration > BIOS/Platform Configuration (RBSU)BIOS/Platform Configuration (RBSU) > Memory OptionsMemory Options >
Persistent Memory OptionsPersistent Memory Options > PMM OptionsPMM Options > Sanitize OptionsSanitize Options, and select the following:
Sanitize/Erase Operation on RebootSanitize/Erase Operation on Reboot :
No Action
Cryptographic Erase
Overwrite Media
Cryptographic Erase and Overwrite Media
Policy after Sanitize/Erase Operation on RebootPolicy after Sanitize/Erase Operation on Reboot :
Sanitize/Erase and Reboot System
Sanitize/Erase and Power System Off
Sanitize/Erase and Reboot to System Utilities
Sanitize/Erase to Factory Defaults and Power System Off
2. Enable the Perform Sanitize/Erase Operation onPerform Sanitize/Erase Operation on selection.
3. Select the HPE Persistent Memory modules to sanitize:
All PMMs in the System—Sanitizes all HPE Persistent Memory modules in the server.
All PMMs on Processor X—Sanitizes all HPE Persistent Memory modules on the specified processor.
Processor X DIMM Y—Sanitizes only the specified HPE Persistent Memory module on the processor.
4. To save your changes and exit, press the F12F12 key.
5. If required, reboot the server.
Sanitization with UEFI System Utilities 186