103
7 Configuration
Image after reset, Image after Home-Button:
Additional settings may be required for a visualization to be displayed by the device. For example, batch-
es can only be displayed if they are appropriately configured by the user.
Input simulation
NOTE!
The inputs and outputs adopt an undefined status. This parameter should only be activated for test pur-
poses and also only if no digital outputs are connected.
Show bar graph Yes, No "Yes" releases the "Bar graph" visualiza-
tion for selection by the user.
Show text image Yes, No "Yes" releases the "Text image" visual-
ization for selection by the user.
Show process
screen
Yes, No "Yes" releases the "Process screen" vi-
sualization for selection by the user.
Show reports Yes, No "Yes" releases the "Reports" visualiza-
tion for selection by the user.
Display counters/
integrators
Yes, No "Yes" releases the "Counters/Integra-
tors" visualization for selection by the us-
er.
Display batch Yes, No "Yes" releases the "Current batch" and
"Completed batch" visualizations for se-
lection by the user.
Input simulation Yes, No If "Yes" is selected, all inputs and outputs
of the device are ignored and pseudo
data is displayed on the screen.
Show alarms Yes, No "No" suppresses displaying fault and
alarm messages in the status and title
bars.
Barcode -> Batch
mask
Yes, No If "Yes" is selected, the "Current batch"
visualization is automatically shown
when the corresponding barcode is
scanned.
Thousand sep-
arator
Yes, No If "Yes" is selected, a stroke will be used
in certain visualizations as an identifica-
tion marking for numbers above and in-
cluding 1000.
Example:
Lock touchscreen Lock the touchscreen to prevent use. This does not switch off the screen.
No selection Not locked
Digital selector Signal (high active) with which the touch-
screen (screen) is locked while the signal
is active.
Width of auxiliary
line
1 to 3 Width of the auxiliary lines in the curve
diagram
Parameter Selection/settings Description
To Next Page
Loading...
