11
1 Introduction
The accompanying letter for repair (Supplementary sheet for product returns) can be downloaded online
from the manufacturer's website:
http://productreturn.jumo.info
Protection against electrostatic discharge (ESD)
(ESD = electrostatic discharge)
To prevent damage due to ESD, electronic modules or components must be handled, packaged, and
stored in an ESD-protected environment. Measures that protect against electrostatic discharge and elec-
tric fields are described in DIN EN 61340-5-1 and DIN EN 61340-5-2 "Protection of electronic devices
from electrostatic phenomena".
When returning electronic modules or components, please note the following:
• Pack sensitive components only in an environment providing protection against ESD. Workspaces
such as this divert electrostatic charges to ground in a controlled manner and prevent static charges
due to friction.
• Use only packaging intended specifically for ESD-sensitive assemblies/components. These must
consist of conductive plastics.
No liability can be assumed for damage caused by ESD.
CAUTION!
Electrostatic charges occur in non-ESD-protected environments.
Electrostatic discharges can damage modules or components.
For transport purposes, use only the ESD packaging provided.
1.4.4 Disposal
Disposing of the device
Disposing of the packaging material
The entire packaging material (cardboard packaging, inserts, plastic film, and plastic bags) is fully recy-
clable.
DISPOSAL!
Devices and/or replaced parts should not be placed in the refuse bin at the end of their service life as
they consist of materials that can be recycled by specialist recycling plants.
Dispose of the device and the packaging material in a proper and environmentally friendly manner.
For this purpose, observe the country-specific laws and regulations for waste treatment and disposal.
To Next Page
Loading...
Need help?
General
