7 Configuration
170
7.19 Report
A report can be generated for each of the groups. The maximum value, the minimum value, and the av-
erage value of each analog channel referring to the selected reporting period are saved in a report.
NOTE!
Processing any changes to the configuration:
All reports are completed, saved, and restarted. The values of the completed reports in the device are
set to empty, "----". In this case, the results of the completed reports can only be viewed with the
PCA3000 software.
NOTE!
Automatic intermediate results of the "Total" and "Yearly" reports:
The "Total" and "Yearly" reports are saved once a month at the turn of the month, independently of other
reports. They are not completed, but continue to run.
Device dialog (excerpt)
Parameter
Parameter Selection/settings Description
Daily Specifies whether a report runs for a day (24 hours). Completion and restart are de-
termined by the synchronization time parameter.
Off, On If "On", the daily report runs.
Weekly Specifies whether a report runs for a week. Completion and restart are determined
by the day of the week and synchronization time parameters.
Off, On If "On", the weekly report runs.
Day of the week Sunday to Saturday For the weekly report, the day of the
week is used in combination with the
synchronization time parameter as the
report end and restart.
Monthly Specifies whether a report runs for a month. Completion and restart occur at 00:00
on the first day of the month.
Off, On If "On", the monthly report runs.
To Next Page
Loading...
