JUMO LOGOSCREEN 601 - Page 143

143
7 Configuration
Unit Conversion factor for evaluating the measured value (only for the signal type "Ana-
log signal")
The units stated in brackets are used in the device info.
Unit (conversion factor):
l/s (l/s) Liters per second (1)
l/min (l/m) Liters per minute (60)
l/h (l/h) Liters per hour (3600)
m
3
/min (m
3
/m) Cubic meters per minute (0.06)
m
3
/h (m
3
/h) Cubic meters per hour (3.6)
US gallon (US liquid gallon):
US.gal/s (U.g/s) Gallons per second (1/3.7854 =
0.264173)
US.gal/min (U.g/m) Gallons per minute (15.8504)
US.gal/h (U.g/h) Gallons per hour (951.0223)
Customer-specific
Imperial (British) gallon:
Imp.gal/s (I.g/s) Gallons per second (1/4.5461 =
0.219969)
Imp.gal/min (I.g/m) Gallons per minute (13.1982)
Imp.gal/h (I.g/h) Gallons per hour (791.8876)
Conversion/K-
factor
-99999 to 1 to +99999 Factor (pulses per liter) for evaluating the
measured value (only for signal type
"Digital ...")
Output
Unit Selector (see above)
l/s
Unit in which the flow value is displayed.
Customer-specif-
ic factor
-99999 to 1 to +99999 Factor for evaluating the measured value
(only for "customer-specific" unit)
Customer-specif-
ic unit
l/h
Use default text or enter other text.
Flow value unit (only for "customer-spe-
cific" unit)
Decimal places Number of pre-decimal and decimal places for the numerical display of the mea-
sured value
Even if the number of decimal places is fixed, the format is automatically changed
if needed in order to display all digits before the decimal point.
Auto Automatic
XXXXXp No decimal place
XXXXpX One decimal place
XXXpXX Two decimal places
XXpXXX Three decimal places
XpXXXX Four decimal places
Start of display
range
-99999 to 0 to +99999 Lower limit of display range
End of display
range
-99999 to +100 to +99999 Upper limit of display range
Parameter Selection/settings Description
?