Figure 61: Removing a High-Voltage Second-Generation Universal Power Supply Before Installing the
MX960 Router
Removing the Standard Cable Manager Before Installing an MX960 Router with a Lift
To remove the standard cable manager (see Figure 62 on page 269):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
2. Using a 7/16-in. (11 mm) nut driver, unscrew the nuts on the corners of the standard cable manager.
3. Grasp the bottom of the standard cable manager, and pull it straight out from the studs on the front
of the chassis.
268
To Next Page
Loading...
