Juniper MX960 - Removing the Fan Trays before Installing an MX960 Router with a Lift

Figure 62: Removing the Standard Cable Manager
Removing the Fan Trays Before Installing an MX960 Router with a Lift
To remove the upper or lower fan tray (see Figure 63 on page 270 and Figure 64 on page 271, which illustrate
the upper and lower fan trays):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
2. Loosen the captive screw on each side of the fan tray faceplate.
3. Grasp both sides of the fan tray, and pull it out approximately 1 to 3 inches.
4. Press on the two latches located on the inside of the fan tray to release the fan tray from the chassis.
5. Place one hand under the fan tray to support it, and pull the fan tray completely out of the chassis.
269