Juniper MX960 - Tools and Parts Required for MX960 Router Connections

Table 115: Field-Replaceable Units
Hot-Pluggable FRUs
Hot-Removable and Hot-Insertable
FRUs
•
Master Switch Control Board (SCB) (if
nonstop active routing is not configured)
•
Master Routing Engine (if nonstop active
routing is not configured)
•
Switch Control Board (SCB)
(nonredundant)
•
Routing Engine (nonredundant)
•
Solid-state drives (SSDs) of Routing
Engines
•
Air filter
•
Craft interface
•
Backup Switch Control Board (SCB) (if
redundant)
•
Master Switch Control Board (SCB) (if
nonstop active routing is configured)
•
Backup Routing Engine (if redundant)
•
Master Routing Engine (if nonstop active
routing is configured)
•
Dense Port Concentrators (DPCs)
•
Flexible PIC Concentrators (FPCs)
•
Modular Port Concentrators (MPCs)
•
Modular Interface Cards (MICs)
•
PICs
•
AC and DC power supplies (if redundant)
•
Fan tray
RELATED DOCUMENTATION
Taking an MX960 Host Subsystem Offline
Tools and Parts Required to Replace MX960 Hardware Components
Replacing the MX960 Craft Interface | 433
Replacing an MX960 Fan Tray | 456
Replacing the MX960 Air Filter | 453
Tools and Parts Required for MX960 Router Connections
To connect the router to management devices and line cards, you need the following tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
2.5-mm flat-blade (–) screwdriver
•
2.5-mm Phillips (+) screwdriver
378