Midplane REV 02 710-013698 CC6220 MX960 Midplane
FPM Board REV 01 710-014974 JS4208 MX960 Front Panel
Display
PIM Rev 02 740-013110 QCS10375009 Power Inlet Module
PEM 0 Rev 01 740-013682 QCS10374009 PS 1.7kW; 200-240VAC
in
PEM 1 Rev 01 740-013682 QCS10374029 PS 1.7kW; 200-240VAC
in
Routing Engine 0 REV 02 740-013063 1000639065 RE-S-2000
Routing Engine 1 REV 04 740-013063 1000664335 RE-S-2000
CB 0 REV 02.6 710-013385 JM7908 MX960 SCB
CB 1 REV 03 710-013385 JS9412 MX960 SCB
FPC 2 REV 03 710-013699 JS4284 MX960 40GE DPC
CPU REV 04 710-013713 JS9401 MX960 DPC PMB
PIC 0 BUILTIN BUILTIN 10x 1GE
...
Fan Tray 0 REV 01 740-014971 FT0655 MX960 Fan Tray
Fan Tray 1 REV 01 740-014971 FT0653 MX960 Fan Tray
Fan Extender REV 01 710-018051 JZ8674 Extended Cable Manager
Under the Item field, verify that you see all hardware components installed in the chassis, including
the following:
•
FPM Board
•
Fan Tray 0
•
Fan Extender (Description field is Extended Cable Manager)
NOTE: The extended cable manager is shown in command output only in Junos OS Release
8.5 or later.
Dressing the Cables
To dress the cables within the extended cable manager, follow this procedure:
1. With a flatblade or Phillips screwdriver, loosen the two captive screws at the bottom of the cable
routing bay cover (see Figure 102 on page 319). The slots in the cover will rest on their supporting posts
and keep the cover in place.
2. Holding the captive screws, lift the cover straight up and out to remove it from the supporting posts.
Set the cover aside.
317
To Next Page
Loading...
