Juniper MX960 - Replacing Power System Components; Replacing an MX960 AC Power Supply; Removing an MX960 AC Power Supply

CHAPTER 26
Replacing Power System Components
IN THIS CHAPTER
Replacing an MX960 AC Power Supply | 537
Replacing an MX960 DC Power Supply | 546
Replacing an MX960 AC Power Supply Cord | 554
Replacing an MX960 DC Power Supply Cable | 555
Replacing an MX960 AC Power Supply
1.
Removing an MX960 AC Power Supply | 537
2.
Installing a MX960 AC Power Supply | 542
Removing an MX960 AC Power Supply
Before you remove a power supply, be aware of the following:
NOTE: The minimum number of power supplies must be present in the router at all times.
CAUTION: To maintain proper cooling and prevent thermal shutdown of the operating
power supply unit, each power supply slot must contain either a power supply or a
blank panel. If you remove a power supply, you must install a replacement power
supply or a blank panel shortly after the removal.
NOTE: After powering off a power supply, wait at least 60 seconds before turning it back on.
537