Juniper MX960 - Connecting the MX960 Router to the Network; Tools and Parts Required for MX960 Router Connections

CHAPTER 18
Connecting the MX960 Router to the Network
IN THIS CHAPTER
Tools and Parts Required for MX960 Router Connections | 357
Connecting the MX960 Router to Management and Alarm Devices | 358
Connecting the MX960 Router to a Network for Out-of-Band Management | 362
Connecting the MX960 Router to a Management Console or Auxiliary Device | 363
Connecting an MX960 Router to an External Alarm-Reporting Device | 364
Connecting DPC, MPC, MIC, or PIC Cables to the MX960 Router | 365
Connecting the Alarm Relay Wires to the MX960 Craft Interface | 367
Tools and Parts Required for MX960 Router Connections
To connect the router to management devices and line cards, you need the following tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
2.5-mm flat-blade (–) screwdriver
•
2.5-mm Phillips (+) screwdriver
•
Wire cutters
•
Electrostatic discharge (ESD) grounding wrist strap
RELATED DOCUMENTATION
Connecting the MX960 Router to a Network for Out-of-Band Management | 358
Connecting the MX960 Router to a Management Console or Auxiliary Device | 359
Connecting an MX960 Router to an External Alarm-Reporting Device | 360
357