Juniper MX960 - Holding an MX960 DPC

user@host> show chassis fpc pic-status
Slot 2 Online MX960 40GE DPC
PIC 0 Online 10x 1GE
PIC 1 Online 10x 1GE
PIC 2 Online 10x 1GE
PIC 3 Online 10x 1GE
Slot 4 Online MX960 4 XGE DPC
PIC 0 Online 1x 10GE(LAN/WAN)
PIC 1 Online 1x 10GE(LAN/WAN)
PIC 2 Online 1x 10GE(LAN/WAN)
PIC 3 Online 1x 10GE(LAN/WAN)
Slot 7 Offline MX960 4 XGE DPC
For further description of the output from the command, see the CLI Explorer.
RELATED DOCUMENTATION
MX960 Chassis Description | 7
MX960 Dense Port Concentrator Description | 63
MX960 DPC and MPC LEDs on the Craft Interface | 20
Troubleshooting the MX960 DPCs | 657
Replacing an MX960 DPC | 485
Holding an MX960 DPC
When carrying a DPC, you can hold it either vertically or horizontally.
NOTE: A DPC weighs 14.5 lb (6.6 kg). Be prepared to accept the full weight of the DPC as you
lift it.
To hold a DPC vertically:
1. Orient the DPC so that the faceplate faces you. To verify orientation, confirm that the text on the DPC
is right-side up and the electromagnetic interference (EMI) strip is on the right-hand side.
600