Figure 86: Removing the Two Left Acorn Nuts That Secure the Original Top Hat
3. With each hand on a front flange of the top hat, remove the top hat halfway by slowly sliding it straight
away from the chassis (see Figure 87 on page 300).
Be prepared to support the full weight of the top hat (40 lbs [18 kg]).
4. With one hand on each side of the top hat, remove the top hat completely by slowly sliding it straight
away from the chassis (see Figure 88 on page 301).
5. Set the top hat aside where it will not interfere with the remainder of the extended cable manager
installation procedure. The original top hat is no longer needed.
299
To Next Page
Loading...
