NOTE: After a power supply is powered on, it can take up to 60 seconds for status
indicators—such as the status LEDs on the power supply and the show chassis command
display—to indicate that the power supply is functioning normally. Ignore error indicators
that appear during the first 60 seconds.
If any of the status LEDs indicates that the power supply is not functioning normally, repeat the
installation and cabling procedures.
12. On the external management device connected to the Routing Engine, monitor the startup process to
verify that the system has booted properly.
NOTE: If the system is completely powered off when you power on the power supply,
the Routing Engine boots as the power supply completes its startup sequence. Normally,
the router boots from the Junos OS on the CompactFlash card.
After powering on a power supply, wait at least 60 seconds before turning it off. To power
off the system after the Routing Engine finishes booting, see “Powering Off the MX960
Router” on page 352.
RELATED DOCUMENTATION
Connecting Power to a DC-Powered MX960 Router with High-Capacity Power Supplies | 346
Connecting the MX960 Router to Management and Alarm Devices | 358
Preventing Electrostatic Discharge Damage to an MX960 Router
Replacing an MX960 DC Power Supply | 546
351
To Next Page
Loading...
