3. Remove the SSD.
a. Attach an ESD grounding strap to your bare wrist, and connect the strap to an ESD point on the
appliance.
For more information about ESD, see Preventing Electrostatic Discharge Damage in the hardware
guide for your router.
b. Unfasten the thumbscrew that secures the access door in front of the storage drive slots, and open
the door.
c. Slide the lock on the ejector to the unlocked position.
d. Carefully slide the drive out of the slot.
Figure 181: Removing an SSD in the Routing Engine RE-S-X6-64G
4. Reinstall an SSD:
a. Carefully align the sides of the drive with the guides in the slot.
b. Slide the drive into the slot until you feel resistance, carefully ensuring that it is correctly aligned.
c. Close the access door and tighten the thumbscrew to secure the door.
469
To Next Page
Loading...
