Info centre "EasyTouch"
300
Fig. 229
If all switching-on conditions are fulfilled, the
icon is displayed.
• Press the
key to start the calibration.
If rotation of the chopping drum is detected, the min and max current for the cutting drum valve
is calculated and automatically saved.
If no speed is detected on the chopping drum, the automatic calibration process is stopped at
1400 mA.
• Press the
key to stop the calibration.
NOTE
If no current is measured, e.g. because of a cable break to the valve, the calibration process is
automatically interrupted and an error message appears.
To Next Page
Loading...
