Operation
568
Fig. 501
Settings for all lifting unit controls:
Pre-condition:
The required lifting unit control is set for:
– Grass/maize mode, see page 193
– With direct cutting system, see page 203
Changing and saving the setpoint height (working height)/setpoint pressure on the multi-
function lever
• Use the "Raise lifting unit manually" (1) or "Lower lifting unit manually" (3) to move to the
new setpoint height/setpoint pressure.
• Press the "Raise lifting unit automatically" (2) key for approx. 3 seconds.
The new setpoint height/new setpoint pressure is saved.
The working screen of the info centre displays a corresponding information message, see page
182.
Setting and saving the headland position on the multi-function lever
• Press the "Raise lifting unit" (2) or "Lower lifting unit" (1) button to move to the lifting height.
• Press the "Lower lifting unit automatically" key (4) for approx. 3 seconds.
The new lifting height is saved.
The working screen of the info centre displays a corresponding information message, see page
182.
Raise the lifting unit to the set headland position
• Press the "Raise lifting unit automatically" key (4).
The lifting unit is raised to the set lifting height.
Activating the set lifting unit control
• Press the "Lower lifting unit automatically" key (2)
The lifting unit is raised or lowered to the set setpoint height/setpoint pressure.
The working screen of the info centre displays the icon of the set lifting unit control along with
the set setpoint height/setpoint pressure.
Deactivating the set lifting unit control
The set lifting unit control is deactivated:
– If the lifting unit is manually controlled with buttons (1) and (2).
– If the diagnostic electronics detect an error.
To Next Page
Loading...
