Maintenance – supply system
706
Inserting Cutting Blades
Risk of injury due to incorrectly attached components!
Components that are not attached may become detached, causing series injuries to people or
damage to the machine.
• Whenever you change a blade, clean the blade carriers, perforated plates and the blades.
• Whenever you change a blade, you must use new screws and perforated plates.
• After mounting the blades, check the tightening torque of the screws and re-tighten if
necessary.
Fig. 658
• Insert new chopping blades in pairs.
• When installing the blades, observe the installation position of the tapped strips (1). The
surface (a) with the rounded corner must be placed on the blade drum (2), the surface (b)
must be turned away from the blade drum (2).
To Next Page
Loading...
