Error code Description Action
28x.60 The status of stapler motor is not defined (staple
finisher)
A software failure has occurred with the output
option.
Go to
“Transport motor encoder not detected
(staple finisher) service check” on page 154.
28x.61 DMID command is not received for 500 ms after
main motor runs (staple finisher)
A software failure has occurred with the output
option.
28x.62 When finishing job isn't completed yet, the first
DMID command of the next job is received (staple
finisher)
A software failure has occurred with the output
option.
28x.63 Bin clamp motor control timer error (staple
finisher)
A software failure has occurred with the output
option.
28x.64 Bin clamp motor control timer error during tray
holder initial (staple finisher)
A software failure has occurred with the output
option.
28x.65 Bin clamp home position jam (staple finisher)
The bin clamp home position is not detected by
the sensor (bin clamp HP).
28x.66 Bin clamp home position jam (staple finisher)
The sensor (bin clamp HP) does not detect that the
bin clamp has moved from home position.
28x.67 Invalid bin clamp manager state (staple finisher)
A software failure has occurred with the output
option.
4062
Diagnostic information
151
To Next Page
Loading...
