Lexmark T652 - Page 155

Action Yes No
Step 5
Replace the stapler assembly. Go to
“SFP stapler assembly rear
door assembly removal” on page 431.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Paddle home position jam (staple finisher) service check
Action Yes No
Step 1
Check all connections on the staple finisher controller card for
damage. If necessary, replace the connections.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Check the sensor (paddle HP) for damage. If necessary, replace
the sensor. Go to
“Sensor (SFP stapler assembly paddle HP)
removal” on page 443.
Does the problem remain?
Go to step 3. Problem is solved.
Step 3
Replace the staple finisher.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Deflector gate transition to output option not detected (staple finisher) service check
Action Yes No
Step 1
Check all connections on the staple finisher controller card for
damage. If necessary, replace the connections.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Check the sensor (deflector HP) for damage. If necessary, replace
the sensor. Go to
“Sensor (SFP stapler assembly deflector HP)
removal” on page 449.
Does the problem remain?
Go to step 3. Problem is solved.
Step 3
Replace the staple finisher.
Does the problem remain?
Contact next level of
support.
Problem is solved.
4062
Diagnostic information
155