Lexmark T652 - Page 58

5 Remove the jammed paper.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching.
Note: If the paper is not easy to remove, then open the rear door and remove the paper from there.
6 Align and reinstall the print cartridge.
7 Close the front cover.
8 Close the multipurpose feeder door.
9 Press .
200 error messages
Error code Description Action
200.00 Sensor (input) area jam
The media is jammed in the sensor (input) area.
Go to
“Sensor (input) service check” on
page 65.
200.01 Sensor (input) lingering jam (MPF, duplex, or
envelope feeder)
The media reached the sensor (input) but did not
clear it within the specified time.
Go to
“Sensor (input) lingering jam service
check” on page 65.
200.02 Sensor (input) lingering jam
The media reached the sensor (input) but did not
clear it within the specified time.
200.04 Sensor (input) early jam
The media reached the sensor (input) sooner than
the specified time. Wrong config ID causes engine
to assume 500 paper path on 250 model.
Go to
“Sensor (input) early jam service check”
on page 67.
200.06 Sensor (input) early jam
The sensor (input) rebounded once the trailing
edge of the media passed.
Go to
“Sensor (input) service check” on
page 65.
200.07 Sensor (input) late area jam (input option tray)
The media is late reaching the sensor (input)
within the specified time.
Go to
“Sensor (input) late jam service check”
on page 68.
200.08 Sensor (input) early jam
The media reaches the sensor (input) sooner than
the specified time.
Go to
“Sensor (input) early jam service check”
on page 67.
4062
Diagnostic information
58