6-22
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
170: Record and Play Audio Test
This command makes the DVR start recording. When you unkey or press a DTMF digit to stop
recording, it automatically plays it back. This is useful for testing the DVR and for checking
how your signal sounds into the repeater. To use this command enter 170 and unkey, then key
up and talk or enter "170 D" and and start speaking immediately. When through speaking,
unkey and your recording will be played back immediately. The track is automatically erased
after it is played back.
<170>
Parameters:
- 170 is the default command name
171: Record DVR Track (non-prompted)
This command makes the DVR start recording a track. To use this command enter Command
171 TTT D or unkey. Either way, you message will be recorded and stored in track TTT.
<171> t Record track 0..9
<171> tt Record track 00..99
<171> ttt Record track 000..260
Please note that a DVR track that has been recorded before must be erased before it can be
recorded again. This is to avoid accidentally recording over an existing message.
Parameters:
- 171 is the default command name
- T, TT, TTT is the DVR track number (1..3 digits, track 0..260)
To Next Page
Loading...
Need help?
General
