6-1
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Chapter 6: CW, DTMF, Voice and DVR Messages
This chapter deals with all of the different types of messages that can be sent from the
controller: CW, DTMF, synthesized voice and real voice from the digital voice recorder.
Sending of CW Messages
- CW speed and tone control
DTMF regeneration
- Regeneration parameters
Send a Voice message
Play, Record and Erase a Digital Voice Recorder message
Generate one and two tone sequences
DTMF Keypad test
The controller normally figures out which transmitters each message should go to. Responses
to commands go to the port that executed the command, ID's go to the port that needs them,
and courtesy beeps go to all of the repeaters that could hear the audio from the receiver that
caused the ID. Almost all of these defaults can be overridden by the user, if you so desire. For
more information about how the messages are routed and how you can change the default
routing, see Chapter 16 and Appendix A.
To Next Page
Loading...
Need help?
General
