Link Communications RLC-CLUB - Command List by Command Number

Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Command List by Command Number
000: Connect one Port to another Port ..........................................2-3
001: Monitor one Port from another Port ........................................2-4
002: Disconnect one Port from another Port ......................................2-5
003,004: Recall a Port's Connections ...........................................2-6
005,006: Set Up/Recall a Port's Access Mode ....................................2-7
007, 008: Configure, Check DTMF Mute on a Selected Port ..................... 3-3, 3-4
009: Recall Entire Controller's Audio Crosspoint ..................................2-8
010: Re-Program Command Names ............................................5-5
011, 012: Recall Information about a Command Name .............................5-8
013: Set COR and PL Active Levels ............................................2-9
014..019: Not Currently Used ................................................17-8
020: Program a Selected Timer ................................................4-2
021: Recall a Timer Value ..................................................4-13
022: Restart a Selected Timer ................................................4-13
023: Reset a Selected Timer .................................................4-13
024: Set Up RS-232 Serial Baud Rate ..........................................7-3
025: Sets the Time of Day Clock .............................................4-14
026: Recall the Time of Day Clock in Male Speech ...............................4-14
027: Recall the Time of Day Clock in Female Speech .............................4-15
028: Sets the Date .........................................................4-16
029: Recall the Date .......................................................4-17
030: Send a CW Message ....................................................6-2
031: Send a DTMF Sequence .................................................6-3
032: Send Serial Message out the Main Serial Port ................................7-5
033, 034: Not Currently Used ................................................17-8
034: Adjust each ports Internal DVR Record Level ..............................6-32
035: Remotely Reset the Controller ...........................................17-2
036: Send a Voice Message ..................................................6-4
037: Set Audio Routing Variable for Commands In a Macro ........................16-2
038: Kill All Responses Following This Command ...............................16-3
039: Recall the Ports in the Current Audio Routing Variable .......................16-5
040: Send One or Two Tone Sequence .........................................6-5
041: Courtesy Beep Enable/Disable for a Selected Transmitter .......................6-8
042: Set CW Speed for a Selected Port .........................................6-9
043: Set CW 2-Tone Frequencies for a Selected Port .............................6-10
044: Set Up DTMF Regenerate Parameters .....................................6-11
045: Setup Beacon Table ...................................................19-2
046: Start Beacon .........................................................19-3
047: Cancel Beacon .......................................................19-3
048: Start Beacon Using English Words ........................................19-3
049: Configure a Port's Tone Response when in Preaccess ..........................9-2
050: Set Up or Recall Default Audio Routing Variables ...........................16-6
051: Start Dial-Tone .......................................................6-11
052: Audio Test using the Internal DVR .......................................6-31
053: Program a Single Command Macro Sequence ................................8-5
054: Recall Macro Contents ..................................................8-6