6-11
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
044: Set Up DTMF Regenerate Parameters
This command allows you to set up the DTMF regenerate parameters for each attached port.
You may need to use this command to slow your DTMF tones down if a scanning DTMF
decoder is on any of the attached systems that you want the RLC-CLUB to control.
<044> p aaaa bbbb
Parameters:
- 044 is the default command name.
- P is the selected port (1..3)
- AAAA is the length of the DTMF sequence in 10mS steps (0000..9999)
- BBBB is the pause between DTMF digits in 10mS steps (0000..9999)
Default:
Both length and pause set to 100mS lengths
051: Start Dial-Tone
This command allows you to generate a dial tone down for a given time down the port that
requested this command. This command is used to give you an indication that access to the
controller has been accomplished. This is not pre-access, simply dial tone generation. The dial
tone is routed to the port that DTMF requested the command. This command is used in
conjunction with the pre-access macros.
<051>
Parameters:
- 051 is the default command name.
.
Notes:
How to cancel the dial tone once it is running:
1) You can cancel the dial tone with a DTMF digit on the port dial tone is present.
2) When the dial tone timer expires (See Command 020)
To Next Page
Loading...
Need help?
General
