Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Regulatory Information
Federal Communications Commission ( FCC ) Regulations:
To comply with FCC regulations, the following requirements must be met:
The FCC Registration Number of this device and Ringer Equivalence
Number ( 0.7B ), if requested by the telephone company, must be
reported. This information is attached to a label found the bottom of this
device.
The sum of Ringer Equivalence Numbers for all devices connected to a
single telephone line should not exceed 5 for reliable operation.
This device must not be installed on coin-operated telephone lines or
party lines.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Repair work on this device must be done by Link Communications, Inc.
or an authorized repair station.
Made in the U.S.A
Telephone Grounding Precautions:
The autopatch interface on the 'RLC-Club' contains a 3 pole SIDACtor that is used to provide
TM
surge and lightning protection to the circuits of the controller. You will notice that there is a
separate ground terminal provided. This terminal must be connected to an external earth
ground to provide the controller with the designed protection. Do not connect this ground to
your power supply ground terminal. Connection to the power supply ground can damage both
the controller and the power supply incase of a surge/lightning strike on the phone lines.
The autopatch provides 2 fuses (500mA) in series with the phone line (F3 is series with the
telephone TIP, and F2 is series with the telephone RING ciruits). If either or both of the fuses
blow, a surge/lightning incident has occurred. Only replace the fuses with 500mA, pico fuses.
If larger fuses are used, damage to the controllers telephone interface can occur. UL1459
regulations require the fuses, so don't bypass them.
SIDACtor is a registered trademark of Teccor Electronics, Inc.
TM
To Next Page
Loading...
Need help?
General
