17-5
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
079: Recall Command Entry Options for a Port
This command allows you to recall all of the options that were set with command 078.
<079> p
Parameters:
- 079 is the default command name.
- P is the port for which to change the force-execution digit
- 1..3 indicate the corresponding port (3 is the autopatch)
- 4 indicates the serial port
Defaults:
- Chaining is disabled
- Timed execution is disabled
- All ports' force-execution digits default to the 'D' key
To Next Page
Loading...