6-29
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
183: Record a Message on the Internal DVR
This command allows you to record a DVR message on one of the three internal DVR message
tracks. The tracks are limited to 4 seconds for tracks 1 and 2 or 8 seconds for track 3. Track 3
is simply a combination of tracks 1 and 2; don't use track 3 if you are using track 1 or track 2.
<183> s Record a track
Parameters:
- 183 is the default command name.
- S is the DVR track number (1..3)
Examples:
To record track 3 from a radio, key up, enter "183 3", then unkey to execute this
command and tell the controller to get ready to record. After you hear the repeater's courtesy
beep, key up and speak the message you want to be recorded. Unkey when you are through
speaking.
To record track 3 from the autopatch, set your force-execution digit for the autopatch
port (port 3) to a '#' using command 078. Then call up on the reverse patch (which should have
been set up with command 133) and enter your password. Then enter "183 3" and press the '#'
digit. As soon as you release the '#', the DVR will begin recording. When you are done
speaking, press the '#' again to tell the DVR to stop recording.
Notes:
• Track 1 = first 4 seconds
• Track 2 = second 4 seconds
• Track 3 = Track 1 + Track 2 = 8 seconds
• See Command 034 to adjust the record level
• When the DVR stops recording because you unkey or press a DTMF digit, it attempts to back
up and erase the squelch tail or DTMF burst so that your message sounds clean. When it stops
recording because it reaches the end of a track, it does not back up to avoid wasting record
time.
• The audio test track defaults to using track 1, if track 1 has not been recorded. Otherwise it
records on track 2. If you record a message on both tracks then do not use the test track
because it will overwrite the second recorded message.
To Next Page
Loading...
Need help?
General
