14-12
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
141: Set Band Unit for RBI-1 or RLC-ICM
This command allows you to tell the Doug Hall RBI-1 or RLC-ICM which band unit you want
to use. The valid band units are listed in the table below. Of course, you must have a radio that
supports that band unit connected to the RBI-1 for this command to work. When you are going
to a new frequency, you can just enter the frequency with command 142 and the band will be
changed automatically.
<141> b..b
Parameters:
- 141 is the default command name.
- B..B is the band unit you want to select , (enter only as many digits as shown below)
B..B RBI-1 Band Selected RLC-Icom Band Selected
20 Not Available 20MHz (10 meters)
50 Not Available 50MHz (6 meters)
140 140MHz (2 meters) 140MHz (2 meters)
150 Not Available 150MHz
160 Not Available 160MHz
220 220MHz 220MHz
430 430MHz 430MHz
440 440MHz 440MHz
1240 1240MHz 1240MHz
1250 1250MHz 1250MHz
1260 1260MHz 1260MHz
1270 1270MHz 1270MHz
1280 1280MHz 1280MHz
1290 1290MHz 1290MHz
To Next Page
Loading...
Need help?
General
