6-27
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
181: Erase Private Mail
This command throws away the contents of a private mailbox, the last one that was retrieved.
It must be used only after retrieving a private mailbox message with Command 180. It erases
all of the messages in that mailbox, but does not affect any of the other private mailboxes.
<181>
Parameters:
- 181 is the default command name
182: Enable/Disable RLC-DVR1
This command tells the RLC-CLUB if an RLC-DVR1 is installed. If you do not tell the
controller that a DVR1 is installed, it will not work properly. If you tell the controller that a
DVR1 is installed when it is not, it may cause problems, such as the transmitter coming up or
staying up when it shouldn't. The internal DVR is always enabled; this command will not
affect it at all.
<182> x
Parameters:
X is the dvr selected
Number DVR Selected
0 No DVR Installed
1 RLC-DVR1 Installed
To Next Page
Loading...
Need help?
General
