15-4
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
195: Configure HF Mode
This command configures the HF control mode and assigns the HF command prefix digit. It
also tells the RLC-Club that the serial port will be used for HF control rather than for
programming the controller. You must disable HF control before the serial port will work for
programming again.
<195> 0 Disable HF
<195> 1 p Enable HF and set HF prefix digit to 'p'
<195> 2 Turn HF off without enabling or disabling
<195> 3 Recall HF mode settings
Parameters:
p = the HF command prefix digit. This is the digit that must be pressed before any
command is entered in HF mode. It is commonly set to '1'. If you prefer not
to use a prefix digit, just enter "195 1".
Notes:
When you disable HF with "195 0", the HF remote will be turned off if it is in use and it
will be disabled so it cannot be turned back on until it is enabled with this command.
Normally the HF remote will be turned off from the port that is using it, by entering the
HF command prefix digit followed by a '3' (the exit command - see the HF commands
on the following pages). If you need to turn the HF remote off from another port (one
that is not currently controlling the HF remote), you can enter "195 2".
Voice Response:
"HF on/off, key x" where "on/off" indicates whether HF is enabled or disabled (not
whether HF mode is turned on or not) and "x" is the HF command prefix digit. "x" will be
"clear" if no prefix digit is used.
Example:
I want the remote base turned on and I want my HF command prefix digit to be a '1'.
195 1 1
To Next Page
Loading...
Need help?
General
